How to update the firmware on a Leica D810 Touch laser

How to update the firmware on a Leica D810 Touch laser

Instructions

Leica periodically updates the firmware on the Disto D810 Touch laser.  If you experience issues with connectivity or error messages, you can refer to this document for instructions on updating firmware: Leica Firmware instructions .

More Information

In order to update firmware, you will need to connect the laser to a computer, using the USB cord that was included with your laser. 

Applies To:

  • SWCS 4.2
  • SWCS 5

    • Related Articles

    • How to reset a Leica Disto X3 laser to factory defaults

      Summary Occasionally a user may experience issues with their X3 laser that can be resolved through resetting the device to factory defaults. This is always the first step to try if your laser begins to behave oddly. This knowledge base contains ...

    • How to update the firmware on a Leica Disto X3 Laser

      Summary Leica periodically releases firmware updates for the Leica Disto X3 laser. If you experience issues with connectivity or error messages, you should verify that you have the latest firmware, using the instructions below. Note: Updating ...

    • Using a Leica X3 laser with an Android tablet

      Summary For some Android users, when a Leica Disto X3 device is connected via Bluetooth, it renders the on screen keyboard inoperable. In order to use the Disto X3 with an Android device, you will need to install and configure Gboard. Setting Up and ...

    • How to setup a Leica Disto X3 laser to transmit measurements in SalesPRO

      Summary This article describes how to setup a Disto X3 laser to transmit measurements, either into SalesPRO software or into another type of program (Notepad, Excel, Word, etc.) Instructions Turn on your X3 laser (Bluetooth is auto enabled) . Select ...

    • How to setup a Leica Disto D810 to work with Solatech

      This article explains how to setup a Disto D810 laser to send measurements into Solatech. This article assumes that the user already has Laser Measure Quick Entry setup in the Solatech Window Covering Software. Please contact Solatech Support if ...