Setting up Fabrication Software to round measurements from a laser measuring device

Setting up Fabrication Software to round measurements from a laser measuring device

Summary

Solatech Window Covering Software 4.2 (Fabrication), must be setup in a specific way in order for measurements from a laser measuring device to be rounded properly. This article provides instruction on proper setup.

Instructions

  1. From within Solatech, go to File>Preferences
  2. In the left hand column, under Hardware, select Leica Disto
  3. In the right hand column, select the Settings button
  4. On the General tab, place a checkmark to the left of Round Measurements down
  5. Do not place a check mark to the left of only for electronic measurements
  6. Click OK to exit and save

Applies to 

  1. Solatech Fabrication software (v. 4)